Error code
Whirlpool-built Kenmore dryer error code F7 E1
Whirlpool wrote this code, not Kenmore. On a dryer wearing this badge, F7 E1 means: A problem with the motor, the control, or the wiring between them. Which model prefixes can raise it, and what to do next.
- From $95 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
- In writing the price, before anything is opened
What we can confirm
Code F7 E1, from the manufacturer's own documentation
A code is only meaningful together with the machine showing it — the same digits mean different things on different equipment.
The code
F7 E1
A problem with the motor, the control, or the wiring between them.
or call (305) 680-1018
What it narrows down to
A problem with the motor, the control, or the wiring between them
Diagnostic
From $95, credited to the repair
On the same appliance
What else belongs to the dryers
On this make a code belongs to the appliance rather than to a product line. These are the other conditions this machine can display, and the models that can show this one — a display often has more than one thing to say, and the model number decides what any of it costs to put right.
Other codes this appliance can display
Restricted air flow
A problem with the heater or the heater relays
Low or no line voltage
Whirlpool's wording: five consecutive loads were dried without the
Whirlpool identifies this as an inlet thermistor problem —
Whirlpool's wording: an issue with the control unit or
An issue with the user interface or its wiring
A problem with the main control board, the touchpad,
A power failure interrupted the drying cycle
The control lock is on
Whirlpool's wording: the door has not been completely closed
LG's own label is DUCT BLOCK ERROR, and the
The same digits mean different things on different equipment. Search the full code list
In more detail
About Whirlpool-built Kenmore dryer error code F7 E1
Whose code this actually is
Kenmore did not write F7 E1, because Kenmore has never built an appliance. This one is Whirlpool's, and it appears on the dryer that Whirlpool built and Sears sold under the Kenmore badge. Whirlpool, LG and Frigidaire all built dryers for this badge, and all three publish short two-character codes, so a lookup that skips the prefix is a coin toss dressed as an answer.
What it means
A problem with the motor, the control, or the wiring between them.
Which Kenmore models can raise it
The Kenmore dryer whose model number begins 110 — the three digits before the period on the rating plate. Those digits are Whirlpool's, which is why Whirlpool's table is the one that applies to F7 E1 and no other manufacturer's does.
What happens next
- Check the drum turns freely by hand with the power off.
- A drum that binds is a roller or a belt; a drum that spins freely with this code is the motor circuit.
Where this usually goes
The job this most often becomes is diagnostic visit, and that page carries a starting figure and the reasons that move it. A Kenmore dryer in South Florida is almost always on a long horizontal duct carrying humid air, and that duct is behind more heat and airflow codes here than any component inside the machine. Photograph the display before you cut the power: a reset clears F7 E1, and on a Kenmore the characters plus three digits off the plate are most of the diagnosis.
Where this meaning came from
Whirlpool's own documentation: Dryer error codes — Whirlpool Product Help. Kenmore publishes none of its own, which is why every entry on this site names the manufacturer's document instead.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards