Broward · South Florida
Kenmore repair in Pembroke Pines
A wide spread of housing ages, and equipment to match. Legacy series still working after twenty years are a regular sight, and parts for them can take a few days to source.
We cover Pembroke Pines and the rest of Broward: an on-site diagnostic first, the price agreed in writing before anything is opened, and the exact figure confirmed once we have seen the unit.
By unit
What we repair in Pembroke Pines, by Kenmore unit
Start with whichever matches yours. How an appliance is installed shapes the visit as much as the repair does, which is why we ask about it when you book.
-
Single and double · built into cabinetry Kenmore wall oven repair in Pembroke Pines
Built-in wall ovens, single and double, mostly Frigidaire-built. What separates a wall oven from the oven in a range is not the cooking — it is the access. The appliance is fixed into joinery, often at height and often stacked with a microwave above it, and getting to the back of it is a real part of the job rather than a detail.
- Access is a genuine part of the work on these
- Sensor and element cover most of the calls
- A stacked installation changes the visit
-
Top-load and front-load · 110 and 796 Kenmore washer repair in Pembroke Pines
Laundry is where the decode matters most, because a Kenmore washer can be a Whirlpool, an an LG, and those are two genuinely different machines. A 110 and a 796 do not share a pump, a control board, a diagnostic sequence or a code table, and they do not fail the same way. The model number is not a formality on this appliance — it is the difference between the right visit and the wrong one.
- 110 is Whirlpool-built, 796 is LG-built
- Drain, spin and leaks are most of what we see
- Two washers under one badge, and two code tables
-
Upright and chest · garage and utility room Kenmore freezer repair in Pembroke Pines
Standalone uprights and chest freezers, most of them Frigidaire-built or Whirlpool-built, and most of them living somewhere hot: a garage, a utility room, a covered porch. That location is half the diagnosis. A freezer asked to hold zero degrees in a garage that reaches ninety-five is working at the edge of what it was designed for, and it fails differently from one in a kitchen.
- 253 is Frigidaire-built, 106 is Whirlpool-built
- Where it lives decides how it fails here
- Manual-defrost chest units have no defrost circuit to blame
-
Gas, radiant and induction · drop-in Kenmore cooktop repair in Pembroke Pines
Drop-in cooktops — gas, radiant electric and induction. A cooktop is the simplest appliance in the kitchen on gas and one of the most electronic on induction, and the two share almost nothing but the hole they sit in. What they do share is that a single dead zone is usually a component rather than the whole appliance.
- One dead zone is rarely the whole cooktop
- Gas is mechanical, induction is electronic
- The glass itself is the one part we cannot repair
-
Electric and gas · 110, 796 and 417 Kenmore dryer repair in Pembroke Pines
Electric and gas dryers built by Whirlpool, LG and Frigidaire under the badge. On this appliance the single most useful thing we can tell you is that a large share of no-heat and long-cycle calls are the vent rather than the dryer — and in South Florida houses the vent runs are longer, flatter and wetter than the ones these machines were designed around.
- 110 is Whirlpool-built, 796 is LG-built, 417 is Frigidaire-built
- The vent causes more of these calls than any part does
- Gas and electric fail in different places
-
Standalone and undercounter · a machine of its own Kenmore ice maker repair in Pembroke Pines
Standalone and undercounter ice makers, which are a separate appliance from the ice maker built into a refrigerator door. They have their own compressor, their own water path and their own harvest mechanism, and they are designed to run continuously rather than in the background. In South Florida that means they run almost every hour of the year, on water that is hard enough to change how they behave within months.
- A machine in its own right, not a refrigerator part
- Mineral buildup is the common ending here
- Which stage the cycle stops at is the diagnosis
By job
The repairs we are called out for in Pembroke Pines
Starting figures for this equipment in South Florida. What moves them is the model, the access and the part — the exact cost is confirmed after the on-site diagnostic.
-
from $135 Dishwasher door latch repair
A dishwasher that will not start, or that stops partway through, when the real problem is that the machine cannot confirm its door is shut. The latch and its switch are cheap and they fail far more often than a control board does.
- The commonest cause of a dishwasher that will not start
- Switch tested rather than the board blamed
- The door alignment checked in the same visit
-
from $265 Appliance control board repair
The repair we rule in last and quote most carefully. A control board is the most expensive single part on most of these appliances, it is the easiest thing to blame, and on a mass-market unit it is the repair where replacing the appliance sometimes wins. We will say which.
- Ruled in by measurement, never by elimination
- Storm-season damage is a real local cause
- An honest replace-instead answer where it applies
-
from $125 Dishwasher wash performance service
Dishes coming out gritty, filmed or still wet. A large share of these are water, detergent and loading rather than the machine — and on South Florida water the film complaint in particular is usually chemistry rather than a component.
- Water temperature measured at the machine
- Spray arms and filter before any part
- Hard water addressed as hard water
-
from $135 Range hood blower and light repair
A hood that has gone quiet, gone loud, or lost its light. These are the simplest appliances in the kitchen and among the most repairable — a blower, a switch, a lamp and a filter — and a large share of the complaints are about the duct rather than the hood.
- Ducted or recirculating settled first
- A greasy impeller before a new motor
- The simplest appliance here and the most repairable
-
from $225 Dishwasher pump replacement
Where the drain pump or the wash pump has genuinely failed rather than been blocked. The two do different jobs and produce different complaints — one leaves water behind, the other leaves dishes dirty — and telling them apart before ordering is most of the value here.
- Wash and drain pumps are different failures
- Blockage ruled out before a part is named
- The builder's own part number, sourced properly
-
from $235 Induction cooktop repair
An induction top that shuts down mid-cook, refuses a pan, or has lost a zone. More of these turn out to be heat and ventilation than electronics — the power stage lives under the glass and is cooled by a fan, and a cabinet that traps warm air makes a healthy cooktop protect itself.
- Ventilation checked before any board
- Pan compatibility is a real answer, not a brush-off
- One dead zone points at that zone's coil or driver
Nearby
Where else we work near Pembroke Pines
Every place below has its own page, with what the equipment and the access are like there.
Elsewhere in Broward
In more detail
Kenmore repair in Pembroke Pines, in more detail
What Kenmore equipment is like in Pembroke Pines
A wide spread of housing ages, and equipment to match. Legacy series still working after twenty years are a regular sight, and parts for them can take a few days to source.
Pembroke Pines sits in Broward County, and the equipment here follows the housing: older kitchens with appliances fitted into openings that were cut for something else, and newer ones where they were specified with the cabinetry. Both are Kenmore work — cooktops, dishwashers, dryers — and both are diagnosed on site before anything is priced.
Heat, dust and power cuts — what they do to a kitchen full of appliances
Inland the enemy is heat, dust and grease rather than salt. Condensers run hard for more months of the year here than almost anywhere else in the country, and grease that condenses in a hood liner instead of leaving through it comes back as a fan that labors. In Pembroke Pines the appliances we are called out to are usually working exactly as designed — in conditions nobody designed them for.
What that means for the appliances in Pembroke Pines
- The housing here spans decades and so does the equipment in it. The model number decides which conversation we are having, which is why it is the first thing we ask for.
- Dishwasher not cleaning
- Frost building up in the freezer
- Refrigerator warm and freezer cold
- One cooktop burner not working
- Dryer making noise
How a visit in Pembroke Pines is arranged
We ask for the model number from the plate inside the door and a line about what the appliance is doing. That decides which parts ride in the van, and it is the difference between one appointment and two.
- How the appliance is built in, and whether it has ever been pulled out before
- Whether there is a second one — a bar, a pantry, a garage or an outdoor kitchen
- Whether the doors are paneled to match the cabinetry, which changes how they come off and go back
- The diagnosis first, then the scope and the price in writing, and your approval before anything is opened
What it costs, and what moves the figure
Prices in Pembroke Pines are the same as everywhere else we cover: a diagnostic from $95 that is credited toward the repair, and starting figures per job rather than one number for "a repair". What moves it is the model, how the appliance is built into the cabinetry, which part it needs and how quickly that part can be sourced — none of which can be judged over the phone. The repairs we carry out lists what each job involves and the figure it starts at, and the unit pages covers what tends to go wrong on each type.
The exact cost is confirmed after the on-site diagnostic and agreed with you before any work begins. We are an independent repair company — not affiliated with, authorized by, or endorsed by any manufacturer — and our warranty covers the labor we performed.
Before you book
Questions about a visit in Pembroke Pines
Do you cover Pembroke Pines?
Yes. Pembroke Pines is in Broward County and inside the area we work every week. Give us the address when you book, and say how the Kenmore is installed — what has to come apart to reach it matters as much as where it is.
How soon can you get to Pembroke Pines?
We will tell you the earliest slot we can genuinely keep rather than the earliest one that sounds good. Tell us the model number and what the unit is doing when you book: whether we can finish the same day depends on the part far more than on the drive.
Does it cost more because the job is in Pembroke Pines?
No. The diagnostic and the work are priced the same across Miami-Dade, Broward and Palm Beach. What moves the figure is the model, how the unit is built in and which part it needs — never the address. Where access takes longer, we say so before anything is agreed rather than after.
What do you need from me before the visit in Pembroke Pines?
The model number from the data plate, a photograph of the display if anything is showing on it, and a line about what the unit is doing. Those three decide which parts a technician brings, and they are the difference between one visit and two.
Booking a visit in Pembroke Pines
Tell us the model number and what the unit is doing. We will bring the parts that problem usually needs, and you will have a firm price before we start.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards