KenmoreRepair Miami

Error code

LG-built Kenmore dryer error code LE1

LG wrote this code, not Kenmore. On a dryer wearing this badge, LE1 means: LG's wording: the drum is not rotating, from a motor problem. Which model prefixes can raise it, and what to do next.

  • From $95 diagnostic, credited to the repair
  • 59 cities and neighborhoods covered
  • OEM parts available on order
  • In writing the price, before anything is opened

What we can confirm

Code LE1, from the manufacturer's own documentation

A code is only meaningful together with the machine showing it — the same digits mean different things on different equipment.

The code

LE1

LG's wording: the drum is not rotating, from a motor problem.

What it narrows down to

LG's wording: the drum is not rotating, from a motor problem

What you are probably seeing

Dryer making noise

Diagnostic

From $95, credited to the repair

What it looks like from the kitchen

A code names the subsystem; the symptom is what sent you to look at the display in the first place. That page says what it usually turns out to be, cheapest cause first.

  • A hand flat on the top of a running dryer with the load blurred through the door.
    A squeal, a rumble or a thump that was not there before

    Dryer making noise

    A useful symptom, because different noises come from different parts and a description on the phone gets us most of the way there. The parts involved are inexpensive; the labor is the cost, which is why they are usually replaced as a set.

    • The noise itself narrows it a great deal
    • Belt rollers and idler wear together
    • Doing one and leaving the others pays the labor twice
    What it usually means

On the same appliance

What else belongs to the dryers

On this make a code belongs to the appliance rather than to a product line. These are the other conditions this machine can display, and the models that can show this one — a display often has more than one thing to say, and the model number decides what any of it costs to put right.

Other codes this appliance can display

Restricted air flow

A problem with the heater or the heater relays

Low or no line voltage

Whirlpool's wording: five consecutive loads were dried without the

Whirlpool identifies this as an inlet thermistor problem —

Whirlpool's wording: an issue with the control unit or

An issue with the user interface or its wiring

A problem with the main control board, the touchpad,

A problem with the motor, the control, or the wiring between them

A power failure interrupted the drying cycle

The control lock is on

Whirlpool's wording: the door has not been completely closed

The same digits mean different things on different equipment. Search the full code list

In more detail

About LG-built Kenmore dryer error code LE1

Whose code this actually is

Kenmore did not write LE1, because Kenmore has never built an appliance. This one is LG's, and it appears on the dryer that LG built and Sears sold under the Kenmore badge. Whirlpool, LG and Frigidaire all built dryers for this badge, and all three publish short two-character codes, so a lookup that skips the prefix is a coin toss dressed as an answer.

What it means

LG's wording: the drum is not rotating, from a motor problem.

Which Kenmore models can raise it

The Kenmore dryer whose model number begins 796 — the three digits before the period on the rating plate. Those digits are LG's, which is why LG's table is the one that applies to LE1 and no other manufacturer's does.

What happens next

  1. Check the drum turns freely by hand with the power off.
  2. A drum that binds is a roller or a belt. A drum that turns freely with this code is the motor circuit.

Where this usually goes

The job this most often becomes is dryer drum roller and belt repair, and that page carries a starting figure and the reasons that move it. A Kenmore dryer in South Florida is almost always on a long horizontal duct carrying humid air, and that duct is behind more heat and airflow codes here than any component inside the machine. Photograph the display before you cut the power: a reset clears LE1, and on a Kenmore the characters plus three digits off the plate are most of the diagnosis.

Where this meaning came from

LG's own documentation: LG Help Library — error code lists. Kenmore publishes none of its own, which is why every entry on this site names the manufacturer's document instead.

This article is based on:

  • Official manufacturer documentation
  • Internal repair procedures
  • Technician repair history
  • Company quality standards

Tell us the model number and what it is doing.

Call (305) 680-1018