Service
Kenmore dryer drum roller and belt repair
A dryer that squeals, thumps, or turns over without the drum moving. The belt, the rollers and the idler wear together and replacing one of the three on its own usually buys a few months.
- From $95 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
- In writing the price, before anything is opened
Before you read on
What this job costs and how it is agreed
A starting figure, not a quote. What moves it is the model, how the unit is built in and which part it needs — settled after the on-site diagnostic.
Starts at
from $165
After a diagnostic from $95, which comes off the bill when you go ahead.
or call (305) 680-1018
Diagnostic
From $95, credited to the repair
The price
In writing, before anything is opened
Warranty
On the labor we performed
On the visit
How this visit actually goes
The same order every time, so nothing is opened and nothing is charged before you have seen the figure and said yes.
-
01
Identify the noise
A squeal, a rumble and a thump come from different parts, and a description on the phone gets us most of the way there.
-
02
Open it up and look at all three
Belt, rollers, idler pulley and the rear bearing. They wear together because they work together.
-
03
Replace as a set where it makes sense
The parts are inexpensive and the labor is the cost. Doing one and leaving the others is paying for the labor twice.
-
04
Check the blower while it is open
Lint packs into the blower housing and it is the easiest moment there will ever be to clear it.
-
05
Run it and listen
A full cycle, empty and then loaded, before we put the panels back on for good.
Applies to
The Kenmore units we carry this work out on
-
Electric and gas · 110, 796 and 417 Kenmore dryer repair in Miami
Electric and gas dryers built by Whirlpool, LG and Frigidaire under the badge. On this appliance the single most useful thing we can tell you is that a large share of no-heat and long-cycle calls are the vent rather than the dryer — and in South Florida houses the vent runs are longer, flatter and wetter than the ones these machines were designed around.
- 110 is Whirlpool-built, 796 is LG-built, 417 is Frigidaire-built
- The vent causes more of these calls than any part does
- Gas and electric fail in different places
In more detail
About Kenmore dryer drum roller and belt repair
About drum noise and broken belts
A belt, a pair of rollers and an idler pulley together cost very little. This figure is almost entirely the work of opening a dryer, lifting the drum out, replacing what is worn and putting it back so it runs true and quiet, and we would rather say that than pretend the parts are expensive. The whole set goes back because everything in the drive train has done the same hours: a new belt on worn rollers wears quickly, and returning for the rollers means paying for the same dismantling twice.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards
Before you book
Questions about Kenmore dryer drum roller and belt repair
It rumbles and squeaks but still dries.
That is the moment to call. Noise here is cheap to put right and gets more expensive the longer it runs, because a worn support damages what turns on it.
What does the noise tell you?
Rumbling usually means rollers, a rhythmic squeak often means the idler, a thump on every rotation can be a flat spot, and a hum with no rotation is a broken belt. Describing it accurately when you book genuinely helps.
Where we do it
Across Miami-Dade, Broward, and Palm Beach
Same terms everywhere we go: an on-site diagnostic first, the price agreed in writing, and the exact figure confirmed once we have seen the unit.
Neighborhoods people ask for by name