Miami-Dade · South Florida
Kenmore repair in Star Island
Large estates, usually with several units across a main house, a guest house and an outdoor kitchen. We would rather look at all of them in one visit than come back for each.
Star Island is a neighborhood of Miami Beach, in Miami-Dade. We cover it on the same terms as the rest of the county: an on-site diagnostic first, the price agreed in writing, and the exact figure confirmed once we have seen the unit.
By unit
What we repair in Star Island, by Kenmore unit
Start with whichever matches yours. How an appliance is installed shapes the visit as much as the repair does, which is why we ask about it when you book.
-
Upright and chest · garage and utility room Kenmore freezer repair in Star Island
Standalone uprights and chest freezers, most of them Frigidaire-built or Whirlpool-built, and most of them living somewhere hot: a garage, a utility room, a covered porch. That location is half the diagnosis. A freezer asked to hold zero degrees in a garage that reaches ninety-five is working at the edge of what it was designed for, and it fails differently from one in a kitchen.
- 253 is Frigidaire-built, 106 is Whirlpool-built
- Where it lives decides how it fails here
- Manual-defrost chest units have no defrost circuit to blame
-
Top-load and front-load · 110 and 796 Kenmore washer repair in Star Island
Laundry is where the decode matters most, because a Kenmore washer can be a Whirlpool, an an LG, and those are two genuinely different machines. A 110 and a 796 do not share a pump, a control board, a diagnostic sequence or a code table, and they do not fail the same way. The model number is not a formality on this appliance — it is the difference between the right visit and the wrong one.
- 110 is Whirlpool-built, 796 is LG-built
- Drain, spin and leaks are most of what we see
- Two washers under one badge, and two code tables
-
Single and double · built into cabinetry Kenmore wall oven repair in Star Island
Built-in wall ovens, single and double, mostly Frigidaire-built. What separates a wall oven from the oven in a range is not the cooking — it is the access. The appliance is fixed into joinery, often at height and often stacked with a microwave above it, and getting to the back of it is a real part of the job rather than a detail.
- Access is a genuine part of the work on these
- Sensor and element cover most of the calls
- A stacked installation changes the visit
-
French door · side-by-side · top and bottom freezer Kenmore refrigerator repair in Star Island
The appliance the badge is best known for, and the one where knowing who built it changes the repair most. A Kenmore refrigerator in a South Florida kitchen is a Whirlpool, a Frigidaire or an LG underneath, and the first three digits of the model number say which. That decides the parts, the diagnostic sequence and whether there is a published code table to read at all — so it is the first thing we ask for.
- 106 is Whirlpool, 253 is Frigidaire, 795 is LG
- Ice, water and the defrost circuit are most of the call volume
- The parts catalog is the builder's, not the badge's
-
Built-in · Kenmore and Kenmore Elite Kenmore dishwasher repair in Star Island
Built-in dishwashers. 665 is the number on most of the plates we see and it is Whirlpool-built; 587 is Frigidaire and 630 is Bosch, and all three turn up in South Florida kitchens. Whirlpool publishes a real code scheme for these, which makes a dishwasher one of the more readable appliances on this badge — provided you read the code against the right builder's table.
- 665 is Whirlpool, 587 is Frigidaire, 630 is Bosch
- Drainage and wash performance are most of the calls
- The code on the display is Whirlpool's code
-
Freestanding and slide-in · gas and electric Kenmore range repair in Star Island
Freestanding and slide-in ranges, gas and electric. 790 is the number we see most and it is Frigidaire-built; 362 turns up on GE-built ranges and 911 on another range family altogether. A range is the appliance a household notices fastest when it stops, and it is also the one where the difference between a sensor, an element and a control board is the difference between a modest repair and a conversation about replacing it.
- 790 is Frigidaire, 362 is GE, 911 is a range prefix too
- Oven sensor and bake element are most of the calls
- Gas surface problems are usually the igniter, not the valve
By job
The repairs we are called out for in Star Island
Starting figures for this equipment in South Florida. What moves them is the model, the access and the part — the exact cost is confirmed after the on-site diagnostic.
-
from $145 Oven sensor and calibration service
An oven that is consistently out by a fixed amount, or one that overshoots and undershoots. The first is often a calibration offset the control already provides for; the second is usually the temperature sensor, and calibrating around it only hides it.
- A fixed offset and a drifting one are different problems
- Measured against a reference probe
- Calibration where calibration is the honest answer
-
from $235 Induction cooktop repair
An induction top that shuts down mid-cook, refuses a pan, or has lost a zone. More of these turn out to be heat and ventilation than electronics — the power stage lives under the glass and is cooled by a fan, and a cabinet that traps warm air makes a healthy cooktop protect itself.
- Ventilation checked before any board
- Pan compatibility is a real answer, not a brush-off
- One dead zone points at that zone's coil or driver
-
from $95 OEM cross reference and parts sourcing
The job that only exists on a badge-engineered appliance. A Kenmore part number is not the part number the factory used, and on a discontinued unit the difference decides whether the repair is possible at all. We cross-reference the Kenmore number to the builder's own number and tell you plainly whether the part is current, superseded or gone.
- The builder's part number, not the badge's
- Superseded numbers traced rather than guessed
- An honest answer when a part no longer exists
-
from $175 Defrost system repair
A refrigerator that warms up over days while the freezer stays cold is usually a defrost story, and in this climate it is a common one: every time a tired door seal lets damp air in, the evaporator has more ice to clear and the circuit has more work than it was sized for.
- Heater, thermostat and control tested as a circuit
- The seal checked in the same visit, or it comes back
- Ice that returns is the symptom, not the cause
-
from $155 Temperature sensor replacement
The component that fails without looking like anything. A sensor that reports the wrong number makes an appliance hold a temperature it is not at, confidently and without complaint — a refrigerator that is warm while the display says it is cold, or an oven that is consistently twenty-five degrees out.
- Measured against a reference, not against the display
- A consistent offset is its signature
- Cheap to replace and easy to misdiagnose
-
from $145 Dishwasher drain repair
Standing water after a completed cycle. On a Whirlpool-built 665 this frequently arrives with a code on the display, and read against Whirlpool's own table it points at the drain path rather than at the pump — which is the difference between a filter clean and a part.
- The disposer plug checked before anything is opened
- The code read against the builder's own table
- The pump last, because it is usually not the pump
Nearby
Where else we work near Star Island
Every place below has its own page, with what the equipment and the access are like there.
Elsewhere in Miami-Dade
In more detail
Kenmore repair in Star Island, in more detail
What Kenmore equipment is like in Star Island
Large estates, usually with several units across a main house, a guest house and an outdoor kitchen. We would rather look at all of them in one visit than come back for each.
Star Island is part of Miami Beach, in Miami-Dade County, and we treat it as its own call rather than a line on a map: the buildings, the access and the age of the installations differ enough from the rest of the city to change how a visit is planned. What does not change is the work — Kenmore cooktops, dishwashers, dryers, diagnosed on site before anything is priced.
Salt, heat and storms — what they do to a kitchen full of appliances
Close to the water everything ages from the outside in. Salt corrodes the condenser coils and fan motors on the cold side and reaches burner caps, grates and igniters on the hot side, and both fail in the same way: a part that still works, slowly, until the day it does not. In Star Island that turns a cleaning interval into a seasonal job rather than an annual one, on both halves of the kitchen.
What that means for the appliances in Star Island
- Refrigerators — Refrigeration installed outside works against ambient heat all summer and salt air all year, which is why cleaning it is seasonal here rather than annual.
- Range hoods — An outdoor hood ducts into weather rather than out of a wall, and the cap is the part that goes — usually silently, so the first sign is smoke that stays under the roof.
- Ranges — Anything cooking outdoors here spends nine months working against ambient heat that indoor equipment never sees, which shortens the life of every ignition component on it.
- Washer leaking
- Washer will not spin
- Washer will not drain
- Dishwasher will not start
- Dishwasher not cleaning
How a visit in Star Island is arranged
We ask for the model number from the plate inside the door and a line about what the appliance is doing. That decides which parts ride in the van, and it is the difference between one appointment and two.
- In a building: the service elevator window, the loading bay and the hours contractors are allowed to work
- Behind a gate: how visitors are cleared, arranged before the appointment rather than at it
- Whether the doors are paneled to match the cabinetry, which changes how they come off and go back
- The diagnosis first, then the scope and the price in writing, and your approval before anything is opened
What it costs, and what moves the figure
Prices in Star Island are the same as everywhere else we cover: a diagnostic from $95 that is credited toward the repair, and starting figures per job rather than one number for "a repair". What moves it is the model, how the appliance is built into the cabinetry, which part it needs and how quickly that part can be sourced — none of which can be judged over the phone. The repairs we carry out lists what each job involves and the figure it starts at, and the unit pages covers what tends to go wrong on each type.
The exact cost is confirmed after the on-site diagnostic and agreed with you before any work begins. We are an independent repair company — not affiliated with, authorized by, or endorsed by any manufacturer — and our warranty covers the labor we performed.
Before you book
Questions about a visit in Star Island
Do you cover Star Island?
Yes. Star Island is part of Miami Beach, in Miami-Dade County, and it is inside the area we work every week. Give us the address when you book, and say how the Kenmore is installed — what has to come apart to reach it matters as much as where it is.
How soon can you get to Star Island?
We will tell you the earliest slot we can genuinely keep rather than the earliest one that sounds good. Tell us the model number and what the unit is doing when you book: whether we can finish the same day depends on the part far more than on the drive.
Does it cost more because the job is in Star Island?
No. The diagnostic and the work are priced the same across Miami-Dade, Broward and Palm Beach. What moves the figure is the model, how the unit is built in and which part it needs — never the address. Where access takes longer, we say so before anything is agreed rather than after.
What do you need from me before the visit in Star Island?
The model number from the data plate, a photograph of the display if anything is showing on it, and a line about what the unit is doing. Those three decide which parts a technician brings, and they are the difference between one visit and two.
Booking a visit in Star Island
Tell us the model number and what the unit is doing. We will bring the parts that problem usually needs, and you will have a firm price before we start.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards