Repair cost
Kenmore dishwasher drain repair cost
Filter, hose, disposer plug and check valve before anybody discusses a pump. A real share of these end with no part at all, which is why the figure sits below the pump replacement rather than beside it.
- From $95 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
- In writing the price, before anything is opened
The short version
Where this figure comes from
A starting point for built-in appliances in South Florida, published so the number is not a mystery until somebody is standing in your kitchen.
Starts at
from $145
After a diagnostic from $95, which comes off the bill when you go ahead with the work.
or call (305) 680-1018
It is not
A quote for your unit
Exact cost
Confirmed after the on-site diagnostic
Warranty
On the labor we performed
What moves it
Why two of the same job cost different amounts
These apply at the same time and in both directions. Which of them is true of your kitchen is what the on-site diagnostic settles.
-
Whether a disposer was fitted recently
A garbage disposer installed with its dishwasher plug still in place holds water in the tub every single cycle. It is free to fix, it is extremely common, and it gets quoted as a pump more often than any other cause on this list.
-
Where the drain hose runs
The high loop is the difference between a dishwasher that drains and one that siphons back. Installations here get it wrong regularly, and correcting it is minutes.
-
What is in the filter and the sump
Glass, a fruit sticker, a bone fragment. All of them stop a drain and none of them is a part. Whirlpool-built and Frigidaire-built machines differ in how easily the sump comes apart, and that is inside the figure.
-
Which builder's check valve it is
665 is a Whirlpool, 587 is a Frigidaire and 630 is a Bosch. Their drain paths are laid out differently and the check valve lives in a different place on each.
-
Whether the machine has to come out
A blockage in the hose behind the cabinets means pulling the dishwasher out of the run and putting it back level. That is real time and it is why this is a 'from'.
The work itself
What we actually do
The job behind the figure: what it involves, when a symptom points at it, and what we check first.
-
from $145 Dishwasher drain repair
Standing water after a completed cycle. On a Whirlpool-built 665 this frequently arrives with a code on the display, and read against Whirlpool's own table it points at the drain path rather than at the pump — which is the difference between a filter clean and a part.
- The disposer plug checked before anything is opened
- The code read against the builder's own table
- The pump last, because it is usually not the pump
In more detail
About Kenmore dishwasher drain repair cost
The order these actually resolve in
Disposer plug, drain hose and its loop, filter, sump, check valve, then pump. That is a sequence built from how often each one turns out to be the answer, and it runs from free to expensive in almost exactly that order. Anybody starting at the far end of it is starting at the rarest outcome.
Three builders, three drain layouts
A dishwasher wearing this badge is a Whirlpool, a Frigidaire or a Bosch underneath, and they do not lay out a sump the same way. Knowing which one is in front of you before the door comes off is not pedantry; it is the difference between a straightforward visit and a long one.
What we leave you with
A machine that drains, and an explanation of what stopped it. Where the cause was an installation problem rather than a failure — and on this complaint it very often is — you get told that plainly, because the same thing will happen again if nobody corrects it.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards
Before you book
Questions about Kenmore dishwasher drain repair cost
There is standing water in the bottom every time.
Start with the disposer plug if one was fitted, then the filter. Between them those two account for most of the standing-water calls we take on this catalog.
Will you replace the pump if the drain is blocked?
No. A pump that is being asked to push through a blockage is not a broken pump. Clearing the path and proving the pump afterwards is the correct order and the cheaper one.
Where we do it
Across Miami-Dade, Broward, and Palm Beach
Same terms everywhere we go: an on-site diagnostic first, the price agreed in writing, and the exact figure confirmed once we have seen the unit.
Neighborhoods people ask for by name