Broward · South Florida
Kenmore repair in Seven Isles
Canal houses with kitchens built for entertaining and a good deal of equipment in them. Something running slightly out of specification is the call we take most often here.
Seven Isles is a neighborhood of Fort Lauderdale, in Broward. We cover it on the same terms as the rest of the county: an on-site diagnostic first, the price agreed in writing, and the exact figure confirmed once we have seen the unit.
By unit
What we repair in Seven Isles, by Kenmore unit
Start with whichever matches yours. How an appliance is installed shapes the visit as much as the repair does, which is why we ask about it when you book.
-
French door · side-by-side · top and bottom freezer Kenmore refrigerator repair in Seven Isles
The appliance the badge is best known for, and the one where knowing who built it changes the repair most. A Kenmore refrigerator in a South Florida kitchen is a Whirlpool, a Frigidaire or an LG underneath, and the first three digits of the model number say which. That decides the parts, the diagnostic sequence and whether there is a published code table to read at all — so it is the first thing we ask for.
- 106 is Whirlpool, 253 is Frigidaire, 795 is LG
- Ice, water and the defrost circuit are most of the call volume
- The parts catalog is the builder's, not the badge's
-
Built-in · Kenmore and Kenmore Elite Kenmore dishwasher repair in Seven Isles
Built-in dishwashers. 665 is the number on most of the plates we see and it is Whirlpool-built; 587 is Frigidaire and 630 is Bosch, and all three turn up in South Florida kitchens. Whirlpool publishes a real code scheme for these, which makes a dishwasher one of the more readable appliances on this badge — provided you read the code against the right builder's table.
- 665 is Whirlpool, 587 is Frigidaire, 630 is Bosch
- Drainage and wash performance are most of the calls
- The code on the display is Whirlpool's code
-
Freestanding and slide-in · gas and electric Kenmore range repair in Seven Isles
Freestanding and slide-in ranges, gas and electric. 790 is the number we see most and it is Frigidaire-built; 362 turns up on GE-built ranges and 911 on another range family altogether. A range is the appliance a household notices fastest when it stops, and it is also the one where the difference between a sensor, an element and a control board is the difference between a modest repair and a conversation about replacing it.
- 790 is Frigidaire, 362 is GE, 911 is a range prefix too
- Oven sensor and bake element are most of the calls
- Gas surface problems are usually the igniter, not the valve
-
Under-cabinet and chimney · ducted and recirculating Kenmore range hood repair in Seven Isles
Under-cabinet and chimney hoods, and this is the one appliance on the badge with a ventilation specialist behind it — the 233 prefix is Broan. There is not much to a hood: a motor, a switch, a lamp and a path for the air. Which is why most of what we are called about turns out to be the duct or the filters rather than the hood.
- 233 is Broan-built — a ventilation maker, not an appliance one
- Most complaints are the duct or the filters
- Recirculating hoods cannot extract, by design
-
Standalone and undercounter · a machine of its own Kenmore ice maker repair in Seven Isles
Standalone and undercounter ice makers, which are a separate appliance from the ice maker built into a refrigerator door. They have their own compressor, their own water path and their own harvest mechanism, and they are designed to run continuously rather than in the background. In South Florida that means they run almost every hour of the year, on water that is hard enough to change how they behave within months.
- A machine in its own right, not a refrigerator part
- Mineral buildup is the common ending here
- Which stage the cycle stops at is the diagnosis
-
Electric and gas · 110, 796 and 417 Kenmore dryer repair in Seven Isles
Electric and gas dryers built by Whirlpool, LG and Frigidaire under the badge. On this appliance the single most useful thing we can tell you is that a large share of no-heat and long-cycle calls are the vent rather than the dryer — and in South Florida houses the vent runs are longer, flatter and wetter than the ones these machines were designed around.
- 110 is Whirlpool-built, 796 is LG-built, 417 is Frigidaire-built
- The vent causes more of these calls than any part does
- Gas and electric fail in different places
By job
The repairs we are called out for in Seven Isles
Starting figures for this equipment in South Florida. What moves them is the model, the access and the part — the exact cost is confirmed after the on-site diagnostic.
-
from $175 Oven door lock repair
A door that locked itself during a self-clean cycle and will not release, or one that refuses to lock when it should. The mechanism is easy to damage by forcing, and a forced door turns a modest repair into a larger one.
- Nearly always a self-clean cycle that did not complete
- Do not force it — that is the expensive mistake
- Motor switch and control tested separately
-
from $225 Dishwasher pump replacement
Where the drain pump or the wash pump has genuinely failed rather than been blocked. The two do different jobs and produce different complaints — one leaves water behind, the other leaves dishes dirty — and telling them apart before ordering is most of the value here.
- Wash and drain pumps are different failures
- Blockage ruled out before a part is named
- The builder's own part number, sourced properly
-
from $95 OEM cross reference and parts sourcing
The job that only exists on a badge-engineered appliance. A Kenmore part number is not the part number the factory used, and on a discontinued unit the difference decides whether the repair is possible at all. We cross-reference the Kenmore number to the builder's own number and tell you plainly whether the part is current, superseded or gone.
- The builder's part number, not the badge's
- Superseded numbers traced rather than guessed
- An honest answer when a part no longer exists
-
from $119 Dryer vent cleaning
The single most useful thing anybody can do for a dryer here, and the honest answer to a large share of no-heat and long-cycle calls. South Florida vent runs are longer and flatter than the ones these machines were designed around, and they carry damp air that packs lint down rather than blowing it through.
- The answer more often than any part is
- Airflow measured at the outside hood
- Prevents the heat-circuit repair that follows it
-
from $125 Condenser cleaning service
The cheapest work on this site and the work that prevents the most expensive. Dust, pet hair and salt air settle on a condenser here until it can no longer give up its heat, and from then on the compressor buys the same cold with more running time — until something in the circuit stops paying.
- Prevents the repair that costs ten times as much
- Salt air and humidity make this a shorter interval here
- Run time measured before and after
-
from $165 Surface igniter replacement
A gas burner that clicks and clicks and will not light. Clicking means the spark system is alive and trying, which rules out a great deal — and it is very often the burner cap seating or a blocked port rather than the igniter at all.
- Cap seating and ports checked first, for free
- Igniter tested rather than assumed
- The gas valve is rarely the answer
Nearby
Where else we work near Seven Isles
Every place below has its own page, with what the equipment and the access are like there.
Elsewhere in Broward
In more detail
Kenmore repair in Seven Isles, in more detail
What Kenmore equipment is like in Seven Isles
Canal houses with kitchens built for entertaining and a good deal of equipment in them. Something running slightly out of specification is the call we take most often here.
Seven Isles is part of Fort Lauderdale, in Broward County, and we treat it as its own call rather than a line on a map: the buildings, the access and the age of the installations differ enough from the rest of the city to change how a visit is planned. What does not change is the work — Kenmore cooktops, dishwashers, dryers, diagnosed on site before anything is priced.
Salt, heat and storms — what they do to a kitchen full of appliances
Close to the water everything ages from the outside in. Salt corrodes the condenser coils and fan motors on the cold side and reaches burner caps, grates and igniters on the hot side, and both fail in the same way: a part that still works, slowly, until the day it does not. In Seven Isles that turns a cleaning interval into a seasonal job rather than an annual one, on both halves of the kitchen.
What that means for the appliances in Seven Isles
- Range hoods — Salt reaches the far end of a duct before it reaches anything in the kitchen. A wall cap with a corroded damper that no longer opens leaves a smoky room behind a hood that sounds perfectly healthy.
- Refrigerators — Condenser coils and fan motors within a few blocks of the water corrode years ahead of the schedule written for a dry climate, and a condenser that cannot shed heat shows up first as a compartment that will not quite hold.
- Cooktops — Burner caps, grates and igniter electrodes take the salt here. An igniter sparking through corrosion is an igniter that clicks and does not light, and it happens on a shorter schedule near the water.
- Refrigerator not cooling
- Refrigerator leaking water
- Dishwasher not draining
- Washer will not drain
- Washer will not start
How a visit in Seven Isles is arranged
We ask for the model number from the plate inside the door and a line about what the appliance is doing. That decides which parts ride in the van, and it is the difference between one appointment and two.
- In a building: the service elevator window, the loading bay and the hours contractors are allowed to work
- Behind a gate: how visitors are cleared, arranged before the appointment rather than at it
- Whether the doors are paneled to match the cabinetry, which changes how they come off and go back
- The diagnosis first, then the scope and the price in writing, and your approval before anything is opened
What it costs, and what moves the figure
Prices in Seven Isles are the same as everywhere else we cover: a diagnostic from $95 that is credited toward the repair, and starting figures per job rather than one number for "a repair". What moves it is the model, how the appliance is built into the cabinetry, which part it needs and how quickly that part can be sourced — none of which can be judged over the phone. The repairs we carry out lists what each job involves and the figure it starts at, and the unit pages covers what tends to go wrong on each type.
The exact cost is confirmed after the on-site diagnostic and agreed with you before any work begins. We are an independent repair company — not affiliated with, authorized by, or endorsed by any manufacturer — and our warranty covers the labor we performed.
Before you book
Questions about a visit in Seven Isles
Do you cover Seven Isles?
Yes. Seven Isles is part of Fort Lauderdale, in Broward County, and it is inside the area we work every week. Give us the address when you book, and say how the Kenmore is installed — what has to come apart to reach it matters as much as where it is.
How soon can you get to Seven Isles?
We will tell you the earliest slot we can genuinely keep rather than the earliest one that sounds good. Tell us the model number and what the unit is doing when you book: whether we can finish the same day depends on the part far more than on the drive.
Does it cost more because the job is in Seven Isles?
No. The diagnostic and the work are priced the same across Miami-Dade, Broward and Palm Beach. What moves the figure is the model, how the unit is built in and which part it needs — never the address. Where access takes longer, we say so before anything is agreed rather than after.
What do you need from me before the visit in Seven Isles?
The model number from the data plate, a photograph of the display if anything is showing on it, and a line about what the unit is doing. Those three decide which parts a technician brings, and they are the difference between one visit and two.
Booking a visit in Seven Isles
Tell us the model number and what the unit is doing. We will bring the parts that problem usually needs, and you will have a firm price before we start.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards