Service
Kenmore dishwasher door latch repair
A dishwasher that will not start, or that stops partway through, when the real problem is that the machine cannot confirm its door is shut. The latch and its switch are cheap and they fail far more often than a control board does.
- From $95 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
- In writing the price, before anything is opened
Before you read on
What this job costs and how it is agreed
A starting figure, not a quote. What moves it is the model, how the unit is built in and which part it needs — settled after the on-site diagnostic.
Starts at
from $135
After a diagnostic from $95, which comes off the bill when you go ahead.
or call (305) 680-1018
Diagnostic
From $95, credited to the repair
The price
In writing, before anything is opened
Warranty
On the labor we performed
On the visit
How this visit actually goes
The same order every time, so nothing is opened and nothing is charged before you have seen the figure and said yes.
-
01
Confirm the machine has power
A dead dishwasher and a dishwasher that will not confirm its door are different problems with the same appearance from the kitchen.
-
02
Test the door switch
Continuity through the switch as the door closes. This is the measurement that separates a latch from a board.
-
03
Look at the strike and the alignment
A door that has dropped, or a cabinet that has moved, makes a good latch miss.
-
04
Fit and adjust
So it closes with the effort it was designed for. A latch that needs a shove wears out its replacement.
-
05
Start a cycle and interrupt it
Opened and closed mid-cycle to prove the switch does its job in both directions.
Applies to
The Kenmore units we carry this work out on
-
Built-in · Kenmore and Kenmore Elite Kenmore dishwasher repair in Miami
Built-in dishwashers. 665 is the number on most of the plates we see and it is Whirlpool-built; 587 is Frigidaire and 630 is Bosch, and all three turn up in South Florida kitchens. Whirlpool publishes a real code scheme for these, which makes a dishwasher one of the more readable appliances on this badge — provided you read the code against the right builder's table.
- 665 is Whirlpool, 587 is Frigidaire, 630 is Bosch
- Drainage and wash performance are most of the calls
- The code on the display is Whirlpool's code
In more detail
About Kenmore dishwasher door latch repair
About a dishwasher that will not start
A dishwasher will not run unless it is certain the door is shut, which is exactly right and which makes a small component capable of stopping the whole appliance. Three findings sit behind one symptom: the mechanism has broken, the switch behind it has failed while the mechanism works, or both are fine and the door has simply dropped so that it no longer arrives where they expect it. The third needs no part at all. Before any of that, control lock is worth ruling out — every builder behind this badge publishes it and it gets switched on by accident constantly.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards
Before you book
Questions about Kenmore dishwasher door latch repair
The lights come on but nothing starts.
Try the control lock first. If the door also has to be leaned on before it closes, the latch is the next suspect.
It leaks slightly at the door as well.
That is usually the seal, but a door no longer closing squarely will produce both. Worth having them looked at in the same visit.
Where we do it
Across Miami-Dade, Broward, and Palm Beach
Same terms everywhere we go: an on-site diagnostic first, the price agreed in writing, and the exact figure confirmed once we have seen the unit.
Neighborhoods people ask for by name