Repair cost
Kenmore dishwasher door latch repair cost
The cheapest dishwasher line on this site, because the part is inexpensive and accessible on all three of the companies that build these — and because it is the commonest reason a dishwasher will not start at all.
- From $95 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
- In writing the price, before anything is opened
The short version
Where this figure comes from
A starting point for built-in appliances in South Florida, published so the number is not a mystery until somebody is standing in your kitchen.
Starts at
from $135
After a diagnostic from $95, which comes off the bill when you go ahead with the work.
or call (305) 680-1018
It is not
A quote for your unit
Exact cost
Confirmed after the on-site diagnostic
Warranty
On the labor we performed
What moves it
Why two of the same job cost different amounts
These apply at the same time and in both directions. Which of them is true of your kitchen is what the on-site diagnostic settles.
-
Whether it is the latch or the switch behind it
The mechanism can be perfect while the switch that tells the control the door is shut has failed. They are different parts and the machine behaves identically.
-
Whether the door has dropped
Springs and cables wear, and a door that no longer closes squarely will not latch reliably however good the latch is. Correcting that is part of the repair.
-
Which builder's assembly it is
Whirlpool-built, Frigidaire-built and Bosch-built latches are laid out differently and some come as an assembly with the handle. That is where the price varies.
-
Whether the control panel has to come off
On most of these the latch lives behind the panel, which means the door has to be opened up. It is straightforward work and it is most of the labor.
-
Whether the machine is locked rather than broken
Control lock is published as a code by every one of these companies and it produces a dishwasher that ignores its buttons. It is not a repair, and we would rather find it on the phone.
The work itself
What we actually do
The job behind the figure: what it involves, when a symptom points at it, and what we check first.
-
from $135 Dishwasher door latch repair
A dishwasher that will not start, or that stops partway through, when the real problem is that the machine cannot confirm its door is shut. The latch and its switch are cheap and they fail far more often than a control board does.
- The commonest cause of a dishwasher that will not start
- Switch tested rather than the board blamed
- The door alignment checked in the same visit
In more detail
About Kenmore dishwasher door latch repair cost
A cheap part that stops the whole machine
A dishwasher will not run unless it is certain the door is shut, and quite rightly. That certainty comes from a small switch and a modest mechanism, and when either of them stops being convincing the appliance behaves as if it has died. It is the most disproportionate failure on the catalog: a machine with nothing wrong with it, stopped by a component worth very little.
Latch, switch, or alignment
Three different findings behind one symptom. The mechanism can be broken, the switch can have failed while the mechanism works, or both can be fine and the door can simply no longer arrive where they expect it. Testing separates them in a few minutes, and the third one needs no part at all.
Before you book
Try the control lock. Every company behind this badge publishes it, every one of them locks the panel in a slightly different way, and between them they account for a genuine share of the dishwashers we are called out to that have nothing wrong with them.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards
Before you book
Questions about Kenmore dishwasher door latch repair cost
The lights come on but nothing starts.
Check for control lock first — it is a published feature on all three builders and it is switched on by accident constantly. If the door also has to be leaned on to close, the latch is your next suspect.
It leaks a little at the door.
That is usually the seal rather than the latch, but a door that is not closing squarely will do both. Worth having them looked at together.
Where we do it
Across Miami-Dade, Broward, and Palm Beach
Same terms everywhere we go: an on-site diagnostic first, the price agreed in writing, and the exact figure confirmed once we have seen the unit.
Neighborhoods people ask for by name