Service
Kenmore cooktop element repair
One radiant zone dead while the others work. That pattern is good news: it points at that element or its switch rather than at anything shared, and both are accessible parts on most of these cooktops.
- From $95 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
- In writing the price, before anything is opened
Before you read on
What this job costs and how it is agreed
A starting figure, not a quote. What moves it is the model, how the unit is built in and which part it needs — settled after the on-site diagnostic.
Starts at
from $155
After a diagnostic from $95, which comes off the bill when you go ahead.
or call (305) 680-1018
Diagnostic
From $95, credited to the repair
The price
In writing, before anything is opened
Warranty
On the labor we performed
On the visit
How this visit actually goes
The same order every time, so nothing is opened and nothing is charged before you have seen the figure and said yes.
-
01
Confirm which zones work
All of them, at more than one setting. A zone that works on high and not on low is a switch rather than an element.
-
02
Test the element
Continuity and resistance. Radiant elements fail open and it is a quick measurement.
-
03
Test the switch
The infinite switch that runs it, which fails more often than people expect and is inexpensive.
-
04
Check the connections
Heat damage at the terminals is common and it is the reason a replacement fails early.
-
05
Look at the glass
A cracked top is a safety stop rather than a repair, and where the glass is no longer made for that model we will tell you rather than take a fee to find out.
Applies to
The Kenmore units we carry this work out on
-
Gas, radiant and induction · drop-in Kenmore cooktop repair in Miami
Drop-in cooktops — gas, radiant electric and induction. A cooktop is the simplest appliance in the kitchen on gas and one of the most electronic on induction, and the two share almost nothing but the hole they sit in. What they do share is that a single dead zone is usually a component rather than the whole appliance.
- One dead zone is rarely the whole cooktop
- Gas is mechanical, induction is electronic
- The glass itself is the one part we cannot repair
-
Freestanding and slide-in · gas and electric Kenmore range repair in Miami
Freestanding and slide-in ranges, gas and electric. 790 is the number we see most and it is Frigidaire-built; 362 turns up on GE-built ranges and 911 on another range family altogether. A range is the appliance a household notices fastest when it stops, and it is also the one where the difference between a sensor, an element and a control board is the difference between a modest repair and a conversation about replacing it.
- 790 is Frigidaire, 362 is GE, 911 is a range prefix too
- Oven sensor and bake element are most of the calls
- Gas surface problems are usually the igniter, not the valve
In more detail
About Kenmore cooktop element repair
About radiant cooktop repairs
A radiant zone is an element and a switch that cycles it. A dead zone is usually the element; a zone with no control over its heat, stuck on full whatever the setting, is almost always the switch. Both are inexpensive parts on every company behind this badge and both are reachable once the surface is up, which is why this figure sits well below the induction one. The glass is the exception: a crack, a chip at an edge or an impact mark is a replacement rather than a repair, and on this catalog a replacement surface is often a large fraction of a new cooktop.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards
Before you book
Questions about Kenmore cooktop element repair
One zone stays on full whatever I set it to.
That is the infinite switch nearly every time. The element is doing what it is told; the thing telling it has stuck.
Can a cracked glass top be repaired?
No. It can be replaced, and we will tell you what that costs against a new appliance rather than quoting a repair nobody should buy.
Where we do it
Across Miami-Dade, Broward, and Palm Beach
Same terms everywhere we go: an on-site diagnostic first, the price agreed in writing, and the exact figure confirmed once we have seen the unit.
Neighborhoods people ask for by name