Service
Kenmore washer leak repair
Water on the floor, which is rarely where the leak is. We work from where it lands back to where it comes from — the door gasket, the dispenser, the hoses, the tub seal — because a leak diagnosed by the puddle is a leak diagnosed wrong.
- From $95 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
- In writing the price, before anything is opened
Before you read on
What this job costs and how it is agreed
A starting figure, not a quote. What moves it is the model, how the unit is built in and which part it needs — settled after the on-site diagnostic.
Starts at
from $155
After a diagnostic from $95, which comes off the bill when you go ahead.
or call (305) 680-1018
Diagnostic
From $95, credited to the repair
The price
In writing, before anything is opened
Warranty
On the labor we performed
On the visit
How this visit actually goes
The same order every time, so nothing is opened and nothing is charged before you have seen the figure and said yes.
-
01
Find out when it leaks
Fill, wash, drain or spin. Which part of the cycle puts water on the floor narrows it more than anything else can.
-
02
The gasket and the door
On a front-loader, the fold of the boot catches lint and small items and starts weeping long before it visibly tears.
-
03
Dispenser and hoses
A blocked dispenser overflows behind the panel. Fill hoses are checked as a matter of course — a burst one is the most expensive thing a laundry room can do.
-
04
The drain path
Pump housing, clamps and the connection at the standpipe.
-
05
The tub seal, last
It happens and it is a serious job. Everything ahead of it on this list is cheaper and more likely, so it goes last.
Applies to
The Kenmore units we carry this work out on
-
Top-load and front-load · 110 and 796 Kenmore washer repair in Miami
Laundry is where the decode matters most, because a Kenmore washer can be a Whirlpool, an an LG, and those are two genuinely different machines. A 110 and a 796 do not share a pump, a control board, a diagnostic sequence or a code table, and they do not fail the same way. The model number is not a formality on this appliance — it is the difference between the right visit and the wrong one.
- 110 is Whirlpool-built, 796 is LG-built
- Drain, spin and leaks are most of what we see
- Two washers under one badge, and two code tables
In more detail
About Kenmore washer leak repair
About tracing a washer leak
The components that leak on a washing machine are cheap — a clamp, a length of hose, a door boot, a dispenser gasket. What takes time is establishing which one, on a machine where water runs down the inside of a cabinet and appears somewhere else entirely. That is why this is priced on the diagnosis. The single most useful thing you can tell us is which part of the cycle it leaks in, because fill, wash, drain and spin each point at a different component. The tub seal is the expensive exception and it is separated out rather than folded into the figure.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards
Before you book
Questions about Kenmore washer leak repair
It only leaks sometimes.
Then note when. Filling, washing, draining or spinning — that observation alone usually narrows it to two candidates before anybody arrives.
Water is under the machine but the front is dry.
Common, and it usually means a hose or a clamp inside rather than the door or the detergent drawer. It also means it has been leaking longer than you think.
Where we do it
Across Miami-Dade, Broward, and Palm Beach
Same terms everywhere we go: an on-site diagnostic first, the price agreed in writing, and the exact figure confirmed once we have seen the unit.
Neighborhoods people ask for by name