Broward · South Florida
Kenmore repair in Weston
Planned neighborhoods where whole phases share a specification, so we usually know the unit before we arrive. Most are now well past their original coverage.
We cover Weston and the rest of Broward: an on-site diagnostic first, the price agreed in writing before anything is opened, and the exact figure confirmed once we have seen the unit.
By unit
What we repair in Weston, by Kenmore unit
Start with whichever matches yours. How an appliance is installed shapes the visit as much as the repair does, which is why we ask about it when you book.
-
French door · side-by-side · top and bottom freezer Kenmore refrigerator repair in Weston
The appliance the badge is best known for, and the one where knowing who built it changes the repair most. A Kenmore refrigerator in a South Florida kitchen is a Whirlpool, a Frigidaire or an LG underneath, and the first three digits of the model number say which. That decides the parts, the diagnostic sequence and whether there is a published code table to read at all — so it is the first thing we ask for.
- 106 is Whirlpool, 253 is Frigidaire, 795 is LG
- Ice, water and the defrost circuit are most of the call volume
- The parts catalog is the builder's, not the badge's
-
Built-in · Kenmore and Kenmore Elite Kenmore dishwasher repair in Weston
Built-in dishwashers. 665 is the number on most of the plates we see and it is Whirlpool-built; 587 is Frigidaire and 630 is Bosch, and all three turn up in South Florida kitchens. Whirlpool publishes a real code scheme for these, which makes a dishwasher one of the more readable appliances on this badge — provided you read the code against the right builder's table.
- 665 is Whirlpool, 587 is Frigidaire, 630 is Bosch
- Drainage and wash performance are most of the calls
- The code on the display is Whirlpool's code
-
Freestanding and slide-in · gas and electric Kenmore range repair in Weston
Freestanding and slide-in ranges, gas and electric. 790 is the number we see most and it is Frigidaire-built; 362 turns up on GE-built ranges and 911 on another range family altogether. A range is the appliance a household notices fastest when it stops, and it is also the one where the difference between a sensor, an element and a control board is the difference between a modest repair and a conversation about replacing it.
- 790 is Frigidaire, 362 is GE, 911 is a range prefix too
- Oven sensor and bake element are most of the calls
- Gas surface problems are usually the igniter, not the valve
-
Under-cabinet and chimney · ducted and recirculating Kenmore range hood repair in Weston
Under-cabinet and chimney hoods, and this is the one appliance on the badge with a ventilation specialist behind it — the 233 prefix is Broan. There is not much to a hood: a motor, a switch, a lamp and a path for the air. Which is why most of what we are called about turns out to be the duct or the filters rather than the hood.
- 233 is Broan-built — a ventilation maker, not an appliance one
- Most complaints are the duct or the filters
- Recirculating hoods cannot extract, by design
-
Standalone and undercounter · a machine of its own Kenmore ice maker repair in Weston
Standalone and undercounter ice makers, which are a separate appliance from the ice maker built into a refrigerator door. They have their own compressor, their own water path and their own harvest mechanism, and they are designed to run continuously rather than in the background. In South Florida that means they run almost every hour of the year, on water that is hard enough to change how they behave within months.
- A machine in its own right, not a refrigerator part
- Mineral buildup is the common ending here
- Which stage the cycle stops at is the diagnosis
-
Electric and gas · 110, 796 and 417 Kenmore dryer repair in Weston
Electric and gas dryers built by Whirlpool, LG and Frigidaire under the badge. On this appliance the single most useful thing we can tell you is that a large share of no-heat and long-cycle calls are the vent rather than the dryer — and in South Florida houses the vent runs are longer, flatter and wetter than the ones these machines were designed around.
- 110 is Whirlpool-built, 796 is LG-built, 417 is Frigidaire-built
- The vent causes more of these calls than any part does
- Gas and electric fail in different places
By job
The repairs we are called out for in Weston
Starting figures for this equipment in South Florida. What moves them is the model, the access and the part — the exact cost is confirmed after the on-site diagnostic.
-
from $165 Dryer drum roller and belt repair
A dryer that squeals, thumps, or turns over without the drum moving. The belt, the rollers and the idler wear together and replacing one of the three on its own usually buys a few months.
- Belt rollers and idler replaced as a set
- The noise identified before anything is opened
- Cheap parts and a real amount of labor
-
from $155 Refrigerator not cooling repair
The most common call there is, and the one most often quoted as a sealed system when it is not. The order of investigation depends on who built the cabinet, which is why we ask for the prefix first — a Whirlpool-built 106 and an LG-built 795 arrive at this symptom by different routes and report it differently.
- Nothing gets named until the setting and the airflow are ruled out
- The route depends on the builder, and we read it first
- Sealed system last, because it is last in reality
-
from $185 Washer spin and drive repair
A load that comes out soaking, or a machine that fills, washes and then refuses to spin. The cheap answers come first here and they are right most of the time: balance, then the lid or door lock, then the drive.
- Balance and the lock before the drive
- Three builders, three drive systems
- The expensive answers are genuinely last
-
from $265 Appliance control board repair
The repair we rule in last and quote most carefully. A control board is the most expensive single part on most of these appliances, it is the easiest thing to blame, and on a mass-market unit it is the repair where replacing the appliance sometimes wins. We will say which.
- Ruled in by measurement, never by elimination
- Storm-season damage is a real local cause
- An honest replace-instead answer where it applies
-
from $145 Dishwasher drain repair
Standing water after a completed cycle. On a Whirlpool-built 665 this frequently arrives with a code on the display, and read against Whirlpool's own table it points at the drain path rather than at the pump — which is the difference between a filter clean and a part.
- The disposer plug checked before anything is opened
- The code read against the builder's own table
- The pump last, because it is usually not the pump
-
from $175 Oven door lock repair
A door that locked itself during a self-clean cycle and will not release, or one that refuses to lock when it should. The mechanism is easy to damage by forcing, and a forced door turns a modest repair into a larger one.
- Nearly always a self-clean cycle that did not complete
- Do not force it — that is the expensive mistake
- Motor switch and control tested separately
Nearby
Where else we work near Weston
Every place below has its own page, with what the equipment and the access are like there.
Elsewhere in Broward
In more detail
Kenmore repair in Weston, in more detail
What Kenmore equipment is like in Weston
Planned neighborhoods where whole phases share a specification, so we usually know the unit before we arrive. Most are now well past their original coverage.
Weston sits in Broward County, and the equipment here follows the housing: older kitchens with appliances fitted into openings that were cut for something else, and newer ones where they were specified with the cabinetry. Both are Kenmore work — cooktops, dishwashers, dryers — and both are diagnosed on site before anything is priced.
Heat, dust and power cuts — what they do to a kitchen full of appliances
Inland the enemy is heat, dust and grease rather than salt. Condensers run hard for more months of the year here than almost anywhere else in the country, and grease that condenses in a hood liner instead of leaving through it comes back as a fan that labors. In Weston the appliances we are called out to are usually working exactly as designed — in conditions nobody designed them for.
What that means for the appliances in Weston
- Whole streets here were built to one specification, so we frequently know the model before we arrive and can bring what it usually needs on the first visit.
- Washer will not spin
- Dryer not drying
- Oven not heating
- Range hood not pulling air
- Ice maker not making ice
How a visit in Weston is arranged
We ask for the model number from the plate inside the door and a line about what the appliance is doing. That decides which parts ride in the van, and it is the difference between one appointment and two.
- How the appliance is built in, and whether it has ever been pulled out before
- Whether there is a second one — a bar, a pantry, a garage or an outdoor kitchen
- Whether the doors are paneled to match the cabinetry, which changes how they come off and go back
- The diagnosis first, then the scope and the price in writing, and your approval before anything is opened
What it costs, and what moves the figure
Prices in Weston are the same as everywhere else we cover: a diagnostic from $95 that is credited toward the repair, and starting figures per job rather than one number for "a repair". What moves it is the model, how the appliance is built into the cabinetry, which part it needs and how quickly that part can be sourced — none of which can be judged over the phone. The repairs we carry out lists what each job involves and the figure it starts at, and the unit pages covers what tends to go wrong on each type.
The exact cost is confirmed after the on-site diagnostic and agreed with you before any work begins. We are an independent repair company — not affiliated with, authorized by, or endorsed by any manufacturer — and our warranty covers the labor we performed.
Before you book
Questions about a visit in Weston
Do you cover Weston?
Yes. Weston is in Broward County and inside the area we work every week. Give us the address when you book, and say how the Kenmore is installed — what has to come apart to reach it matters as much as where it is.
How soon can you get to Weston?
We will tell you the earliest slot we can genuinely keep rather than the earliest one that sounds good. Tell us the model number and what the unit is doing when you book: whether we can finish the same day depends on the part far more than on the drive.
Does it cost more because the job is in Weston?
No. The diagnostic and the work are priced the same across Miami-Dade, Broward and Palm Beach. What moves the figure is the model, how the unit is built in and which part it needs — never the address. Where access takes longer, we say so before anything is agreed rather than after.
What do you need from me before the visit in Weston?
The model number from the data plate, a photograph of the display if anything is showing on it, and a line about what the unit is doing. Those three decide which parts a technician brings, and they are the difference between one visit and two.
Booking a visit in Weston
Tell us the model number and what the unit is doing. We will bring the parts that problem usually needs, and you will have a firm price before we start.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards